Launch monitor
Ball speed efficiency.
When a well-swung shot comes up short, ball speed efficiency shows how much of your club speed reached the ball. It's ball speed divided by club speed, often called smash factor. Put the strike in the middle of the face and see what the number does.
By Dwain Kinghorn · Updated
What to look for.
- Where it comes from
- A launch monitor (TrackMan), not the video
- Where to find it
- The Swing Scorecard's TrackMan rows, on a swing with TrackMan data attached
- Ball speed efficiency is ball speed divided by club speed, often called smash factor.
- A centered strike raises it and more loft lowers it, so only compare it within one club.
- Strike location, on the same scorecard, is the first place to look when it drops.
Understanding the idea.
Two things set the number: where the ball met the face, and how much loft you delivered. A centered strike gives a higher number than one off the toe or heel. More loft gives a lower number by design. That's why a wedge's efficiency is lower than a driver's even when you strike both well.
These ranges come from TrackMan: the middle 80 percent of the tour swings MotionEdge has for that club. They show where good players land. They aren't a number to aim for. With irons, most tour swings fall between about 1.34 and 1.44, with the middle near 1.39. With a pitching wedge, between about 1.20 and 1.29. With the driver, between about 1.46 and 1.50.
Only compare the number within one club. The off-center strike guide covers moving the strike toward the middle, which is the most direct way to raise it.
How to use this idea.
A shot you loft up on purpose, a soft wedge or a punch changes the number with nothing wrong. One high reading isn't a trend. Read the whole set.
A practice cue.
Put the strike mark in the middle of the face.
Try the exercise.
Strike-and-efficiency set
Spray the face of a mid-iron or put impact tape on it. On a launch monitor, hit ten balls and note the efficiency and the strike mark for each.
Sort the shots by where the mark landed. Compare the efficiency of the middle strikes with the toe and heel strikes, then hit five more trying only for the middle.
What to record
Compare the average of each set with the same club, and keep a change only when the number repeats and the strike holds up.
Practice set: Hit 2 sets of 10, noting efficiency and the strike mark of each ball.
Keep in mind: Listen for the quiet, solid sound a centered strike makes.
Review the result.
You're looking for a higher average efficiency with the same club, with more marks near the middle. Compare averages. Single shots don't tell you much.
Watch these clips.
These demonstrations offer another way to understand the idea. Each video opens at the selected starting point and continues playing; use the note below it to focus your viewing.
Contact location as part of impact quality, the strike this number reflects.
Launch angle, smash factor, spin rate and attack angle explained at a club-fitting center.